Cable Tray Cover, 50mm (2"), 2–3m Length, Steel (Galvanised/Stainless) or Aluminium, 0.6–1.5mm Thickness, Cover Clamp / Snap-On Fastening

Device Type: Cable Tray Cover (50 mm / 2-inch nominal width)
Brand/Model: Generic – specifications vary by manufacturer (e.g., Vantrunk, OBO Bettermann, Legrand/Cablofil, Pohlcon, Niedax). Verify the brand/model on the physical unit.
Video Output: N/A
Data Ports: N/A (passive cable management accessory; no electrical or data interfaces)
Dimensions & Material (Typical for 50 mm Width):
Nominal Width: 50 mm (2 inches)
Cover Width (Actual): Approximately 59 mm for Vantrunk trays, though most covers are sized to the nominal tray width.
Standard Lengths: 3,000 mm (3 m) for steel covers; 2,000 mm (2 m) for some steel and plastic variants.
Material Options:
Steel: Strip galvanised (Sendzimir), Double Dip (zinc/aluminium), hot-dip galvanised, or stainless steel (316L).
Aluminium: Available as an alternative.
Plate Thickness: 1.0 mm (standard for most steel covers), 1.5 mm (heavy-duty steel covers), 0.6 mm (stainless steel variants), or 0.75 mm (light-duty snap-on covers).
Profile/Height: Typically 13 mm to 35 mm (side height for deeper covers).
Fastening & Installation:
Fastening Methods: Cover clamp (most common), snap-on (tool-less), or screw-on.
Compatibility: Designed for standard cable trays, wire-mesh trays, and some cable ladders. Compatibility varies by model—verify specific tray type.
Outdoor Use: Additional securing (e.g., self-tapping screws or steel cable ties) is required against wind loads; cover clamps alone are not sufficient.
Environmental & Performance:
Operating Temperature (Steel): −20°C to +120°C (stainless steel models).
Corrosion Protection: Galvanised to DIN EN 10346 or corrosion class C1 (for some galvanised covers).
Standards: Steel covers may comply with IEC 61537 / BS EN 61537 for cable tray systems.
Key Specs: 50mm (2") Cable Tray Cover, 2–3m Length, Steel (Galvanised/Stainless) or Aluminium, 0.6–1.5mm Thickness, 13–35mm Profile, Cover Clamp / Snap-On / Screw-On Fastening, −20°C to +120°C, DIN EN 10346 / IEC 61537 Compliant, Suitable for Cable Tray & Mesh Tray (Verify Model)
Usage: Protecting Cable Tray Runs from Dust, Debris & Mechanical Damage, Indoor & Outdoor Cable Routing Systems, Industrial & Commercial Electrical Installations, Data Center & Telecommunication Cable Management, Maintaining Cable Integrity & Safety